Re: onan [message #370568 is a reply to message #361669] |
Tue, 27 September 2022 14:34 |
Bill Van Vlack
Messages: 419 Registered: September 2015 Location: Guemes Island, Washington
Karma:
|
Senior Member |
|
|
wally wrote on Mon, 11 January 2021 15:30
We did efi on the GMC's Onan. Video of start and run here https://www.youtube.com/watch?v=woA-BxJeTIk https://www.youtube.com/watch?v=woA-BxJeTIk
Yamaha and GM bits mixed with Crane and Megasquirt electronics most of it previously used (battle proven) stuff.
I have 20 or so pages on our blog about the setup under Onan efi links. https://wallyandsue.blogspot.com/
Been messing with it for a few years and since we pretty much are stuck at home it got finished. Interesting fuel tune because it runs at 1,800 rpm or off. It's running fixed timing from a battle proven Ford VR crank sensor. I'm using the original carb as a air valve with the choke fixed open and throttle position sensor attached. The governor works exactly like before with the same linkage and valve.
I couldn't find a reference to 'Onan efi' by doing a search on your blog, and the videos were no longer available. Can you send a specific link to that info perhaps?
Cheers,
Bill
Bill Van Vlack
'76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath, Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o mid November 2015.
|
|
|