| Re: Tips/steps to take before removing intake manifold [message #367879 is a reply to message #367683] |
Wed, 08 December 2021 15:19   |
Carl S.
Messages: 4186
Registered: January 2009
Location: Tucson, AZ.
Karma:
|
Senior Member |
|
|
Take pictures of the current installation. It will help you when you go to put all the vacuum lines back in place. Also, label the vacuum lines, trans, advance, PCV. brake, etc. Just get everything as clean as you can. Use a shop vac to clean out the lifter valley. I used Dick Paterson's gasket set with the SS block-off plates. It is the proper thickness, and I felt that the plates would protect the aluminum manifold from the extreme exhaust heat.
Carl Stouffer
'75 ex Palm Beach
Tucson, AZ.
Chuck Aulgur Reaction Arm Disc Brakes, Quadrabags, 3.70 LSD final drive, Lenzi knuckles/hubs, Dodge Truck 16" X 8" front wheels, Rear American Eagles, Solar battery charging. GMCSJ and GMCMI member
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
