GMCforum: GMCnet » Macerator Hose

Home » Public Forums » GMCnet » Macerator Hose

Show: Today's Messages :: Polls :: Message Navigator

Macerator Hose [message #367528]

Mon, 08 November 2021 19:05

Tom Katzenberger

Messages: 399
Registered: June 2019
Location: Kingsville, MD

Karma: 4

Senior Member

Good evening all,

I am trying to find the best option on a 1" macerator hose? Any opinions on what type hose works best?

I am trying to keep it attached to the macerator and stow it in a sub-frame tube.

Thanks for any opinions.

Take care,
Tom K.

Tom & Oki Katzenberger, Kingsville, Maryland, 1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition

Report message to a moderator

Re: Macerator Hose [message #367529 is a reply to message #367528]

Mon, 08 November 2021 19:27

Bill Van Vlack

Messages: 419
Registered: September 2015
Location: Guemes Island, Washington

Karma: 14

Senior Member

This one's worked well for us. We ran a hard 1" pipe to the RR bumper area, then the hose stored in a 2"? PVC electrical conduit that started next to the 1" pipe, went across the back to a pair of 45s and then forward to the first cross member.

https://www.amazon.com/gp/product/B003DIU4C0/

Bill Van Vlack '76 Royale; Guemes Island, Washington; Twin bed, full (DS) side bath, Brazilian Redwood counter and settee tops,455, 6KW generator; new owner a/o mid November 2015.

[Updated on: Mon, 08 November 2021 19:28]

Report message to a moderator

[GMCnet] Re: Macerator Hose [message #367530 is a reply to message #367528]

Mon, 08 November 2021 19:18

Emery Stora

Messages: 959
Registered: January 2011

Karma: 4

Senior Member

Tom

I have been using a 3/4” garden hose for years.
I bought a 50 foot red rubber hose from Home Depot years back. I cut it in half and fastened the half with the male hose end to the macerator by using a 1” to 3/4” adapter. That adapter was not in the plumbing section of Home Depot but I found it in the lawn sprinkler section. I purchased a short piece of 1” hose to fasten between the macerator and the adapter.
I used a brass cap to screw onto the end of the drain hose.

I rolled up the other 25 foot piece of hose with the female hose end and stored in the propane compartment. If I need more length to reach a drain I just screw that piece onto the end of the macerator hose.
I store the macerator hose in a 20 foot piece of 1-1/4” pic which I fastened to the driver’s side frame.

The 3/4” hose is more than adequate for a drain hose. One time I even put a 25’ length of 5/8” garden hose between the two 25’ lengths of 3/4” hose. There was no problem pumping out the tank.

You can see pictures here: http://www.gmcmhphotos.com/photos/g3352-macerator-and-storage-for-hose.html

Emery Stora
77 Kingsley
Frederick, CO

> On Nov 8, 2021, at 6:05 PM, tomkatz3@comcast.net wrote:
>
> Good evening all,
>
> I am trying to find the best option on a 1" macerator hose? Any opinions on what type hose works best?
>
> I am trying to keep it attached to the macerator and stow it in a sub-frame tube.
>
> Thanks for any opinions.
>
> Take care,
> Tom K.
> --
> Tom & Oki Katzenberger,
> Kingsville, Maryland,
> 1977 23' Birchaven, 455 C.I.D.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

Report message to a moderator

[GMCnet] Re: Macerator Hose [message #367532 is a reply to message #367528]

Mon, 08 November 2021 19:36

Rob

Messages: 651
Registered: November 2013
Location: Victoria, BC

Karma: 3

Senior Member

I used a 1 inch poly suction hose. I cut it and attached one end to the macerator output and brought the female quick connect fitting up between the Onan and battery. I attached a PVC 1/4 turn ball valve to the other section of the hose and added an adapter to a garden hose fitting (just in case I ever need to attach *more* than 20 ft of hose).

Canadian links (that may NOT be 100% correct) - but it might help you visualize things:

Poly hose: https://www.princessauto.com/en/poly-suction-hoses/product/PA1000001572?skuId=8559346
Ball valve: https://www.princessauto.com/en/pvc-ball-compact-valves/product/PA1000001575?skuId=5770034
Adapter for suction hose to ball valve: https://www.amazon.ca/LASCO-15-1633-Adapter-4-Inch-Thread/dp/B00ITPIIQQ
Adapter for other side of ball valve to garden hose: https://www.homedepot.ca/product/rainwave-3-4-inch-brass-double-male-connector/1000837987

My initial plan was to disconnect the poly hose and put a plug in the quick connect between dumps. But that was never necessary - the entire hose rolls up nicely between the Onan and battery. I close the valve and just roll it up, with the valve sitting in behind the battery.

It works amazing well. I *almost* enjoy heading to the Sani-Dump these days.

Rob
76 Royale Twin Beds, Dry Bath
Victoria, BC

> On Nov 8, 2021, at 5:05 PM, wrote:
>
> Good evening all,
>
> I am trying to find the best option on a 1" macerator hose? Any opinions on what type hose works best?
>
> I am trying to keep it attached to the macerator and stow it in a sub-frame tube.
>
> Thanks for any opinions.
>
> Take care,
> Tom K.
> --
> Tom & Oki Katzenberger,
> Kingsville, Maryland,
> 1977 23' Birchaven, 455 C.I.D.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

Rob - Victoria, BC - 76 Royale - Rear Twins/Dry Bath

Report message to a moderator

[GMCnet] Re: Macerator Hose [message #367533 is a reply to message #367532]

Mon, 08 November 2021 19:58

James Hupy

Messages: 6806
Registered: May 2010

Karma: -62

Senior Member

I have a 1978 Royale with a black tank as well as a grey tank. So I had to
connect a mascerator in the extreme rear of the coach on the driver's side.
There is a angle frame member that leaves a tri-angled space that is just
big enough for the mascerator. I used a hole saw and bored a hole in the
long frame member on the drivers side and plumbed the outlet of the
mascerator through the hole and terminated the plumbing right next to the
3" slinky connection. Capped it with a male garden hose threaded connector
and a 1/4 turn shut off just ahead of the hose connector. I put the on/off
switch and fuse holder in the generator compartment behind the louvers. I
just open the door, and flip the switch. I use a piece of 3/4" rubber
hose to connect to the dump station. Have not even had the 3" slinky out of
its sheath for years. Would never go back to no mascerator.
Hint: I always drain the black tank first and follow it with the grey
tank. That rinses the system out very well.
Jim Hupy
Salem, Oregon

On Mon, Nov 8, 2021, 5:37 PM Rob wrote:

> I used a 1 inch poly suction hose. I cut it and attached one end to the
> macerator output and brought the female quick connect fitting up between
> the Onan and battery. I attached a PVC 1/4 turn ball valve to the other
> section of the hose and added an adapter to a garden hose fitting (just in
> case I ever need to attach *more* than 20 ft of hose).
>
> Canadian links (that may NOT be 100% correct) - but it might help you
> visualize things:
>
> Poly hose:
> https://www.princessauto.com/en/poly-suction-hoses/product/PA1000001572?skuId=8559346
> Ball valve:
> https://www.princessauto.com/en/pvc-ball-compact-valves/product/PA1000001575?skuId=5770034
> Adapter for suction hose to ball valve:
> https://www.amazon.ca/LASCO-15-1633-Adapter-4-Inch-Thread/dp/B00ITPIIQQ
> Adapter for other side of ball valve to garden hose:
> https://www.homedepot.ca/product/rainwave-3-4-inch-brass-double-male-connector/1000837987
>
> My initial plan was to disconnect the poly hose and put a plug in the
> quick connect between dumps. But that was never necessary - the entire hose
> rolls up nicely between the Onan and battery. I close the valve and just
> roll it up, with the valve sitting in behind the battery.
>
> It works amazing well. I *almost* enjoy heading to the Sani-Dump these
> days.
>
> Rob
> 76 Royale Twin Beds, Dry Bath
> Victoria, BC
>
>> On Nov 8, 2021, at 5:05 PM,
> wrote:
>>
>> Good evening all,
>>
>> I am trying to find the best option on a 1" macerator hose? Any opinions
> on what type hose works best?
>>
>> I am trying to keep it attached to the macerator and stow it in a
> sub-frame tube.
>>
>> Thanks for any opinions.
>>
>> Take care,
>> Tom K.
>> --
>> Tom & Oki Katzenberger,
>> Kingsville, Maryland,
>> 1977 23' Birchaven, 455 C.I.D.
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

Report message to a moderator

Re: [GMCnet] Re: Macerator Hose [message #367534 is a reply to message #367532]

Tue, 09 November 2021 03:19

boybach

Messages: 566
Registered: December 2020
Location: Vancouver Island

Karma: 4

Senior Member

Rob wrote on Mon, 08 November 2021 17:36

I *almost* enjoy heading to the Sani-Dump these days.

Rob
76 Royale Twin Beds, Dry Bath
Victoria, BC

Unless your pocketful of quarters get kicked out by the dump station meter, eh Rob? Laughing

Larry

Larry - Victoria BC - 1977 ex-Palm Beach "Ol' Leaky" 40,000 miles, PO said everything working but forgot the word NOT. Atwood helium fridge, water heater & furnace. SS exhaust system, Onan, Iota Converter, R134A, New fuel lines & heat exchange hoses

Report message to a moderator

[GMCnet] Re: Macerator Hose [message #367536 is a reply to message #367534]

Tue, 09 November 2021 08:40

Rob

Messages: 651
Registered: November 2013
Location: Victoria, BC

Karma: 3

Senior Member

I avoid the BC Parks dumps for bigger reasons than that!

Having said that - this last season was almost an all time high for me:
*three* BC Parks dumps! It's getting hard to find open Sani-Dumps these
days...

Rob
Victoria, BC
76 Royale - Rear Twins/Dry Bath

On 2021-11-09 1:19 a.m., twlldeen@gmail.com wrote:
> Unless your pocketful of quarters get kicked out by the dump station meter, eh Rob? :lol: :lol:
>
> Larry
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:

Rob - Victoria, BC - 76 Royale - Rear Twins/Dry Bath

Report message to a moderator

Re: [GMCnet] Re: Macerator Hose [message #367538 is a reply to message #367536]

Tue, 09 November 2021 11:37

boybach

Messages: 566
Registered: December 2020
Location: Vancouver Island

Karma: 4

Senior Member

Rob wrote on Tue, 09 November 2021 06:40

I avoid the BC Parks dumps for bigger reasons than that!

Having said that - this last season was almost an all time high for me:
*three* BC Parks dumps! It's getting hard to find open Sani-Dumps these
days...

Rob
Victoria, BC
76 Royale - Rear Twins/Dry Bath

The owner of the place where I keep ol' Leaky installed a personal dump station for me last month - how about that, Rob! Razz

Larry

Report message to a moderator

Previous Topic:	[GMCnet] Refinishing switch bezels?
Next Topic:	EMP

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Sep 20 02:44:26 CDT 2024

Total time taken to generate the page: 0.02213 seconds