| Added a remote Onan switch [message #367337] |
Wed, 27 October 2021 18:01  |
Bruce Hart
Messages: 1500
Registered: October 2011
Location: La Grange, Wyoming
Karma:
|
Senior Member |
|
|
Installed a primer switch on the inside remote panel. Activated the primer switch, start switch and Onan fires right up. When I release the prime switch the Onan dies. I have compared my wiring to the write up on following article:
http://gmcmotorhome.info/onan.htm
Thinking that it could be a bad start/stop I replaced it and got same results.
Any ideas from the crowd?
Powered the primer switch from exterior light switch just inside door(Purple wire).
Remote Onan switch has a run meter and no battery condition meter. On the control board # 5 pin has a wire connected to it and not to #6 which manual and tech write up suggests.
Power Drawer Operators Manual page 8 and 9
Bruce Hart
1976 Palm Beach
1977 28' Kingsley
La Grange, Wyoming
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
