[GMCnet] Re: Caster [message #367127 is a reply to message #367126] |
Sun, 10 October 2021 10:14 |
Keith V
Messages: 2337 Registered: March 2008 Location: Mounds View,MN
Karma:
|
Senior Member |
|
|
Yeah the cams were set all the way in in back and out in front. There is an old school alignment shop that specializes on streetrods. Had it on his rack. So im sure he measured it right.
The problem looks to be mostly on the pass side as the cams on the drivers side are only 1/2 way
So hopefully putting the bushings on the front will fix it
________________________________
From: John R.Lebetski
Sent: Sunday, October 10, 2021 10:00:48 AM
To: gmclist@list.gmcnet.org
Subject: [GMCnet] Re: Caster
Do you have the cams set to pull the rear of the arm inboard? Rear offset should have hole near ball joint as you mentioned. If fronts are done the
the hole should be inboard to move front of arm outboard and balljoint rearward.
How are you measuring caster?
--
John Lebetski
Woodstock, IL
77 Eleganza II
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
Keith Vasilakes
Mounds View. MN
75 ex Royale GMC
ask me about MicroLevel
Cell, 763-732-3419
My427v8@hotmail.com
|
|
|