Oil Pressure Poll [message #366554] |
Tue, 07 September 2021 19:54 |
Greg C.
Messages: 224 Registered: October 2019 Location: Knoxville, TN
Karma:
|
Senior Member |
|
|
So today I got my Autometer oil pressure gauge hooked up. I also have the factory gauge, with a NOS Made In USA Echlin OP6636 sender. I'm currently running 10-30 synthetic oil. Today's temperature was about 82. I started up the engine so I could run my new Viair compressor and evaluate its performance.
On start up, my stock gauge showed a little bit above halfway, and the Autometer gauge showed about (no exact corresponding lines) 30-32 PSI at about 900 RPM. After running a bit and kicking off the fast idle, the Autometer showed 25 PSI @ 650 RPM and 180 degrees water temp.
I went back and messed around with the compressor and checked for leaks for a few minutes. Going back into the cockpit showed 195-200 degrees and about 12-13 PSI of oil pressure at 650 RPM. Revving up to 1500 RPM netted about 30 PSI.
Those of you who have aftermarket gauges, how does this compare to yours?
Greg Crawford
KM4ZCR
Knoxville, TN
"Ruby Sue"
1977 Royale
Rear Bath
403 Engine
American Eagle Wheels
Early Version Alex Sirum Quad bags
|
|
|