[GMCnet] Re: Second Starter Motor Burned out [message #364988 is a reply to message #364897] |
Fri, 25 June 2021 11:07 |
Chris McBride
Messages: 35 Registered: June 2021
Karma:
|
Member |
|
|
Good Morning Matt. The second starter is in and everything seems to be fine, but I could not find a problem with the switch or it's mechanical operation. The tilt wheel mechanism is broken and I heard something drop down the steering column tube and suspect a piece may have temporarily jammed the switch in the "start" position. I will be tackling that project next.
On Tuesday, June 22, 2021, 02:18:32 p.m. EDT, Matt Colie wrote:
Chris McBride wrote on Tue, 22 June 2021 12:51
> Thank you John,Good to know about the firewall solenoid. I will check the ignition switch and the Start power to the solenoid this weekend.
> The starter rebuilder seems to think the solenoid is being energized even after the key is returned from start position.
> Eric Roell76 GlenbrookAurora, Ontario
Eric,
If the complex linkage that works the switch is worn out, that is quite possible. The parts that wear out are usually very available at any
store-front parts store. Many will lend the tools needed to pull the steering wheel and signal switch so you can replace the rack and pinion that do
this. It is not a difficult job with the right tools. Read about it before you start.
Matt
--
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
|
|
|