| Left over parts [message #363218] |
Sun, 04 April 2021 14:12  |
indymac
Messages: 26
Registered: August 2013
Location: Decatur, IN
Karma: 0
|
Junior Member |
|
|
After wrestling with my A/C bracket for two years, I have these parts left over.
Does anyone know where they go?
I hate it when I have even washers left over.
One is a 10 1/4" round support bar/bracket with a half inch hole on one end, and a 7/16" on the other.
The next game from the engine area, looks like a plug wire support with 2 - 1/4" holes, one end with a bolt/washer wear, one end without.
Finally a thick 5/16" washer.
Cannot find any thing in the parts or other manuals.
Thanks,
Jim
77 Palm Beach 403
Decatur, IN
TZE167V101738
|
|
|
|
|
|
| Re: Left over parts [message #363230 is a reply to message #363224] |
Mon, 05 April 2021 09:46  |
indymac
Messages: 26
Registered: August 2013
Location: Decatur, IN
Karma: 0
|
Junior Member |
|
|
Thank you for the offer.
I found a new one in the owners manual, the green one.
B/W and small but it should be the 403.
If no one else chimes in I'll take a rain check.
Thanks!
Jim
77 Palm Beach 403
Decatur, IN
TZE167V101738
|
|
|
|
| Re: Left over parts [message #363243 is a reply to message #363230] |
Mon, 05 April 2021 18:08 |
94nubble
Messages: 275
Registered: July 2011
Location: Chesapeake VA
Karma: 3
|
Senior Member |
|
|
The bar goes from the top back of the alternator to intake manifold. Braces the alternator. 77 78 X7725 manual, 6Y-9 Figure 5 Generator mounting.
The small 2 hole bracket goes on the exhaust manifold . Holds the heat riser pan to the manifold. Parts Book 8.006 part #53
The washer is a spacer that goes between alternator and bottom bracket. Back side.
Tom McManus
1977 Royale
Chesapeake VA
[Updated on: Mon, 05 April 2021 18:11] Report message to a moderator |
|
|
|
| Re: Left over parts [message #363263 is a reply to message #363218] |
Tue, 06 April 2021 09:51 |
Russell K.
Messages: 178
Registered: October 2016
Location: Dunedin, Florida
Karma: 4
|
Senior Member |
|
|
Jim,
Here is a pic that shows two of the parts in your photo. As Tom described, the bar in your pic, and the thick washer are for alternator mounting. The washer is critical for proper belt alignment, and the bar helps support the alternator against the tension of the belt. Ours is also a 403.
http://www.gmcmhphotos.com/photos/showfull.php?photo=65698
Russell
1978 Eleganza II, Dunedin, Florida
|
|
|
|
| Re: Left over parts [message #363381 is a reply to message #363243] |
Mon, 12 April 2021 21:38 |
indymac
Messages: 26
Registered: August 2013
Location: Decatur, IN
Karma: 0
|
Junior Member |
|
|
Thank you very much!
Not sure how I missed them in the parts manual, must have spent 4 hours hunting and seeking.
Muchos gracias
77 Palm Beach 403
Decatur, IN
TZE167V101738
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
