Aluminum Intake [message #362347] |
Fri, 12 February 2021 17:34 |
Greg C.
Messages: 224 Registered: October 2019 Location: Knoxville, TN
Karma:
|
Senior Member |
|
|
Hi all:
I recently obtained an A4 casting number aluminum intake for a late model 307 Olds. I plan to use this intake on my 1977 403. It is an EGR version, and I have been able to remove the two recirculation tubes that go in the primary bores and plan to plug those, as well as the carb heat and EGR valve ports. I have an electric choke.
My question is do I need to use a turkey tray type gasket with this?
I plan to purchase the Paterson gaskets and block off plates if I don't need the turkey tray.
Greg Crawford
KM4ZCR
Knoxville, TN
"Ruby Sue"
1977 Royale
Rear Bath
403 Engine
American Eagle Wheels
Early Version Alex Sirum Quad bags
|
|
|