GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Alternator Question (just curious)
Re: [GMCnet] Alternator Question (just curious) [message #361913 is a reply to message #361907] Fri, 22 January 2021 06:57 Go to previous messageGo to previous message
Ray Erspamer is currently offline  Ray Erspamer   United States
Messages: 1707
Registered: May 2007
Location: Milwaukee Wisconsin
Karma:
Senior Member
I just happened to see it and was curious. I have a perfectly good military grade 27si with an isolated ground and a spare.  It kust looked very similar.Sent from my U.S.Cellular© Smartphone
-------- Original message --------From: Matt Colie via Gmclist Date: 1/21/21 6:29 PM (GMT-06:00) To: gmclist@list.gmcnet.org Cc: Matt Colie Subject: Re: [GMCnet] Alternator Question (just curious) Ray Erspamer wrote on Thu, 21 January 2021 12:22> Will  Delco 24si 165 Amp Alternator work in a  GMC?> https://www.jittruckparts.com/delco-remy-delco-remy-24si-160a-alternator-8600310?gclid=CjwKCAiA6aSABhApEiwA6Cbm__nqIvkprmdfyMrcRSX1djiuDAGSov_6Zb3> L9yrw2v6aZeF0WH-zcxoCsgEQAvD_BwE> Sent from my  U.S.Cellular© SmartphoneRay, Both this and the OE 27SI are J180 hinge mounts, so that much might bolt on and it is a remote sense for the regulator so that is good.  The two issues that bother me are:I could not find my dimensioned drawings of the 27SI to compare, but the front offset might be different so it might be a trick line the belt up. It does not seem to have the tapped hole that is part of the adjustment retention in our installation.  If you are doing this because there is no 27SI available, look around a little more.  Both the 27SI 80& 100s were produced in massive quantities butdon't buy a 27SI 200, because those are a different frame.  If you are doing this to get better charging, be ready to be disappointed.  The problem is not the alternator capability, but the system can't managethe load so the voltage drop in the wiring comes to be the limiting factor.  My 80amp will (given the right conditions) top out short term at 96~98amps, but the single belt would smoke.  The big difference is that my coach is a 23 with the house bank in the right front.Matt     -- Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control ArmsSE Michigan - Near DTW - Twixt A2 and Detroit_______________________________________________GMCnet mailing listUnsubscribe or Change List Options:http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org


Ray Erspamer 78 GMC Royale Center Kitchen 403, 3.70 Final Drive Holley Sniper Quadrajet EFI System, Holley Hyperspark Ignition System 414-484-9431
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Machining Brake Drums
Next Topic: [GMCnet] Billie Kelley (Non-GMC)
Goto Forum:
  


Current Time: Wed Jul 03 00:25:12 CDT 2024

Total time taken to generate the page: 0.01020 seconds