Height Control Valve Link Assembly [message #361575] |
Sat, 09 January 2021 16:26 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma: 4
|
Senior Member |
|
|
Can I steel the parts information from someone with regard to the Height Control Valve Link Assembly? I am looking to fab one using rod ends, jamb nuts and a long hex fittings. I sure many have already constructed this many times in the past.
Thanks all and take care,
Tom
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|
Re: Height Control Valve Link Assembly [message #361587 is a reply to message #361575] |
Sat, 09 January 2021 18:03 |
|
Matt Colie
Messages: 8547 Registered: March 2007 Location: S.E. Michigan
Karma: 7
|
Senior Member |
|
|
Tom Katzenberger wrote on Sat, 09 January 2021 17:26Can I steel the parts information from someone with regard to the Height Control Valve Link Assembly? I am looking to fab one using rod ends, jamb nuts and a long hex fittings. I sure many have already constructed this many times in the past.
Thanks all and take care,
Tom
Tom,
You waited until the light went out...
I'll try to remember to find one of the OE links I replaced.
But I am not going to pick my way across the dog's yard in the dark to do that.
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|