GMCforum: GMCnet » [GMCnet] Stepper Motor Cruise

Home » Public Forums » GMCnet » [GMCnet] Stepper Motor Cruise

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Stepper Motor Cruise [message #359926]

Mon, 02 November 2020 08:35

Dolph Santorine

Messages: 1236
Registered: April 2011
Location: Wheeling, WV

Karma:

Senior Member

I’m installing the GM Stepper motor cruise.

There are two different sets of instructions… one references the VSS input as being “square sine wave” and the other as sine wave (analog).

Any idea which is correct?

Dolph Santorine

dolph@dolphsantorine.com

134 Falls Road
Wheeling, WV 26003

Phone: 304-219-3100
FAX: 304-232-3075

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]

		[GMCnet] Stepper Motor Cruise By: Dolph Santorine on Mon, 02 November 2020 08:35
		Re: [GMCnet] Stepper Motor Cruise By: Dolph Santorine on Mon, 02 November 2020 10:25
		Re: [GMCnet] Stepper Motor Cruise By: Ken Henderson on Mon, 02 November 2020 10:34
		Re: [GMCnet] Stepper Motor Cruise By: Dolph Santorine on Mon, 02 November 2020 17:30
		Re: [GMCnet] Stepper Motor Cruise By: Ken Henderson on Mon, 02 November 2020 17:38
		Re: [GMCnet] Stepper Motor Cruise By: Dolph Santorine on Mon, 02 November 2020 18:27

Previous Topic:	[GMCnet] Paint color
Next Topic:	zerk drilling jig ?

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Mar 14 23:51:48 CDT 2025

Total time taken to generate the page: 0.00490 seconds