GMCforum: GMCnet » Front brake pad thickness

Home » Public Forums » GMCnet » Front brake pad thickness

Show: Today's Messages :: Polls :: Message Navigator

Front brake pad thickness [message #358987]

Sat, 26 September 2020 19:58

Ernest Dankert

Messages: 133
Registered: May 2007
Location: Ogden, New York

Karma:

Senior Member

Just finished new shocks all the way around and new CV joint boots at LF corner. My question for the group, is there a standard wear thickness
for the front brake pads? I have riveted pads and the thickness left is just over 1/4 inch. My rotors were turned and are at minimum thickness.
This is a stock front end and serviced bearings and knuckles by D. Lenzi.

1977 Eleganza II
Ogden NY

Report message to a moderator

[Message index]

		Front brake pad thickness By: Ernest Dankert on Sat, 26 September 2020 19:58
		Re: Front brake pad thickness By: JohnL455 on Sun, 27 September 2020 09:20
		Re: Front brake pad thickness By: Ernest Dankert on Mon, 28 September 2020 13:38
		Re: Front brake pad thickness By: lqqkatjon on Mon, 28 September 2020 15:30
		Re: [GMCnet] Front brake pad thickness By: James Hupy on Mon, 28 September 2020 15:32
		Re: Front brake pad thickness By: lqqkatjon on Mon, 28 September 2020 07:33
		Re: Front brake pad thickness By: Larry on Mon, 28 September 2020 09:31
		Re: Front brake pad thickness By: lqqkatjon on Mon, 28 September 2020 10:29

Previous Topic:	Awning arm measurement needed.
Next Topic:	Beltline Molding

Goto Forum:

-=] Back to Top [=-

Current Time: Mon Oct 07 09:28:47 CDT 2024

Total time taken to generate the page: 0.00745 seconds