Re: [GMCnet] Door adjustment. [message #356869] |
Fri, 17 July 2020 00:10 |
BobDunahugh
Messages: 2465 Registered: October 2010 Location: Cedar Rapids, IA
Karma: 11
|
Senior Member |
|
|
I had the same issue with our 78 Royale. I made an 1/8-inch thick shim. ( You may need more. ) And installed that shim behind the striker pin plate. It will now go to the second lock position. With my little finger.
Bob Dunahugh
78 Royal since 2003
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
Re: [GMCnet] A note as to Door adjustment. [message #356887 is a reply to message #356885] |
Fri, 17 July 2020 10:39 |
Ken Henderson
Messages: 8726 Registered: March 2004 Location: Americus, GA
Karma: 9
|
Senior Member |
|
|
When I removed my hard-pin striker to take it to the machinist as a model,
I discovered that it also has marks on the underside of the flange on the
pin. I'll increase the shim thickness when I reinstall it. Because my
door closes so nicely, I suspect my contact only occurs dynamically, not
when parked & open/closing the door.
Ken
On Fri, Jul 17, 2020 at 11:16 AM Bob Dunahugh via Gmclist <
gmclist@list.gmcnet.org> wrote:
> I was finding that just as the door was touching the lock pin. The door
> would start to move to the left. So, I thought that one of the hinges were
> binding. Or the door was coming in contact with the door jam. Moving a
> piece of paper in the right door jam. Confirmed that that there was
> clearance. That meant that the door latch pin. Was pulling the door at
> closing. to the left. Thus, the shim. As listed below. Problem solved.
> The door hinges can be adjusted. I did that to decrease the door gap
> to the jam.
> Bob Dunahugh
>
> ________________________________
> From: Bob Dunahugh
> Sent: Friday, July 17, 2020 12:10 AM
> To: gmclist@list.gmcnet.org
> Subject: RE: Door adjustment.
>
> I had the same issue with our 78 Royale. I made an 1/8-inch thick shim.
> ( You may need more. ) And installed that shim behind the striker pin
> plate. It will now go to the second lock position. With my little finger.
> Bob Dunahugh
> 78 Royal since 2003
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Ken Henderson
Americus, GA
www.gmcwipersetc.com
Large Wiring Diagrams
76 X-Birchaven
76 X-Palm Beach
|
|
|