GMCforum: GMCnet » Door Curve

Home » Public Forums » GMCnet » Door Curve

Show: Today's Messages :: Polls :: Message Navigator

Door Curve [message #353441]

Thu, 02 April 2020 10:05

MikeB

Messages: 133
Registered: December 2018
Location: South Bama

Karma:

Senior Member

The PO performed the door recurve and over did the bottom half latch side. This is keeping the top and middle pushed out when closing. Has anyone actually taken some of the curve out of the door?

M Beam 75’ Avion TBI EBL , 3.70 LSD and other stuff Zuki Sidekick, Dozier Al

Report message to a moderator

[Message index]

		Door Curve By: MikeB on Thu, 02 April 2020 10:05
		Re: Door Curve By: Richard RV on Thu, 02 April 2020 15:07
		Re: Door Curve By: Bill Van Vlack on Thu, 02 April 2020 15:28
		Re: Door Curve By: Larry on Thu, 02 April 2020 18:20
		Re: Door Curve By: Bill Van Vlack on Thu, 02 April 2020 20:13
		Re: Door Curve By: Larry on Fri, 03 April 2020 20:33
		Re: Door Curve By: MikeB on Fri, 03 April 2020 20:30
		Re: Door Curve By: MikeB on Sat, 04 April 2020 18:08
		Re: Door Curve By: Ken Burton on Sat, 04 April 2020 21:39
		Re: Door Curve By: MikeB on Sun, 05 April 2020 11:48
		Re: Door Curve By: Bill Van Vlack on Sun, 05 April 2020 13:11
		Re: Door Curve By: Richard RV on Sun, 05 April 2020 14:47
		Re: Door Curve By: MikeB on Sun, 05 April 2020 17:18
		Re: Door Curve By: Ken Burton on Fri, 03 April 2020 12:52
		Re: [GMCnet] Door Curve By: jimk on Fri, 03 April 2020 13:21
		Re: [GMCnet] Door Curve By: Ken Burton on Sat, 04 April 2020 00:46

Previous Topic:	[GMCnet] Oil Cooler
Next Topic:	Using a ducted A/C unit in our none ducted coaches?

Goto Forum:

-=] Back to Top [=-

Current Time: Fri Sep 20 14:25:37 CDT 2024

Total time taken to generate the page: 0.04418 seconds