| New dash AC set up [message #349795] |
Fri, 01 November 2019 17:15  |
skip2
Messages: 544
Registered: September 2011
Location: Winter Haven,FL (center o...
Karma:
|
Senior Member |
|
|
Evening all, I've finally gathered up all the goodies from Jim K and an AC supply house to convert my Dash AC to a Sandem compressor and add an underdash unit by teeing into the factory system. Looking for anyone who has done this for any hints or warnings. My biggest question is flushing the old condensor and evaporator really needed. It was cooling at the time the pressure switch blew out. I understand the expansion valve should be removed to clean out the evaporator but that it's a major job to remove. I know I need to get the old oil out of the system since the Sandem uses its special PAG oil. Any Ideals out there or what others have done when converting over. All comments and suggestions will be welcome. Thanks.
Skip Hartline
74 Canyon Lands, FiTech,
3.7 FD LSD, Manny Tranny,
Springfield Distributor,
2001 Chevy Tracker Ragtop Towd
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
