GMCforum: GMCnet » bearings

Home » Public Forums » GMCnet » bearings (Hub and Knucle )

Show: Today's Messages :: Polls :: Message Navigator

bearings [message #349618]

Thu, 24 October 2019 17:16

Gary M

Messages: 16
Registered: August 2018
Location: SW Virginia

Karma:

Junior Member

I am currently replacing the outer CV joints on my coach and checking the rest of the steering components. I checked for any bearing play while the tire was on and did not feel any at all. I have the knuckle off now and there is some play when grabbing the rotor and rocking it back and forth. My question is if there is an acceptable tolerance when the hub and knuckle is off the vehicle?

Can you still get the bushings for the relay lever or need to be sent off for machining? Lower ball joints will also be replaced since they have some play in them.

77 Royale 455 Rear bath, SW Virginia

Report message to a moderator

[Message index]

		bearings By: Gary M on Thu, 24 October 2019 17:16
		Re: [GMCnet] bearings By: James Hupy on Thu, 24 October 2019 17:52
		Re: [GMCnet] bearings By: Gary M on Thu, 24 October 2019 18:51
		Re: bearings By: 6cuda6 on Thu, 24 October 2019 20:03
		Re: [GMCnet] bearings By: jimk on Thu, 24 October 2019 22:56

Previous Topic:	Air System - moved from sandbox
Next Topic:	[GMCnet] Q for Mansfield Attendees

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Nov 05 00:37:23 CST 2024

Total time taken to generate the page: 0.00756 seconds