| Standpipe Vents [message #347284] |
Tue, 03 September 2019 15:43  |
Rich Kinas
Messages: 113
Registered: July 2019
Karma:
|
Senior Member |
|
|
Hey all,
While I am working on the interior and roof, I have to do some work on the standpipe that vents the bathroom sink, the pipe that snakes up beside the frig . So I was looking at it and wondering something. I understand why this standpipe is needed base on the original design layout where the bathroom sink trap ties into the bathroom standpipe then about 6 inches below this "T" the pipe travels over to the toilet standpipe and "T's" into that pipe. However I was wondering if I just ran the bathroom sink trap output directly to the toilet standpipe "T" shouldn't this work just as good? This would allow me to remove the existing sink standpipe and a lot of extra pipe, and allow me to reclaim another 4 inches of space between the bathroom module and the frig module. Also it allows me to close up another roof penetration point 
Thanks again...
Rich Kinas
1976 Elaganza II
Orlando, FL
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
