New Gen 2 Window Latch Installation [message #344570] |
Wed, 26 June 2019 15:26 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma: 4
|
Senior Member |
|
|
Ladies and gentlemen,
Does anyone know of a way to install new Gen2 rear window latches without the removal of the windows? I can not get the nuts which are between the glass from spinning and the new bushings do not fit between the panes.
If I have to remove the glass is there an easy way to do so?
Thanks in advance,
Tom
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
[Updated on: Wed, 26 June 2019 16:11] Report message to a moderator
|
|
|
|
Re: New Gen 2 Window Latch Installation [message #344652 is a reply to message #344650] |
Fri, 28 June 2019 15:53 |
Tom Katzenberger
Messages: 399 Registered: June 2019 Location: Kingsville, MD
Karma: 4
|
Senior Member |
|
|
Michael,
Thank you so much! I will give it a try.
Thanks again,
Tom
Tom & Oki Katzenberger,
Kingsville, Maryland,
1977 23' Birchaven, 455 C.I.D., Micro Level, Howell EBL-EFI Spark Control, Macerator, York Air Compressor, 6 Wheel Disc, Quadra Bag, Onan W/Bovee Ignition
|
|
|