DigiPanel Oil Pressure Sender [message #341979] |
Mon, 25 March 2019 15:21 |
ree_eric
Messages: 43 Registered: February 2004 Location: Alexandria, Ontario, Cana...
Karma:
|
Member |
|
|
Installing the digipanel and I find a sender that I believe came with the kit. It is a 3 pin unit (PS140T) but I don't know what the connections are. Couldn't find the specs online even though it is available everywhere. The stock one is 1 pin. Should I use the stock one with a T wire connector? Is there only one place on the engine for an oil pressure sensor?
Eric & Ree '74 ex-Sequoia (parts) '75 Eleganza (TB, exhaust x-over blocking plates, Manny reaction arms and discs, 3"exhaust rear muffler, aux vacuum, fuel tank sealing, rebuilt senders and new rubber, propane hot water heater.) Alexandria, Ontario, Canada
|
|
|