Gauges [message #338958] |
Thu, 22 November 2018 09:18 |
Eleganza2 Newbie
Messages: 9 Registered: October 2018 Location: Boone, NC USA
Karma:
|
Junior Member |
|
|
Greetings everyone. I posted several days ago that I was struggling to get my gauges to work. Here is what I have done.
Check and replaced the fuse that said "gauges and Trans"
Taken the Dash apart and cleaned the screws and the base plate with a wire brush
Taken a piece of wire and run it from the bolt on the alternator to the dash plate then to the screws holding on the gauges assembly. Then I tried going to the negative terminal on the battery.
I turned on the ignition and still had no results other than the gauges immediately move to the "Full" "Cold" "High" positions and stay pinned there.
Am I not grounding it enough? Is there another option for checking? It seems that since all three of those gauges on the assembly are acting similar it isn't the gauge itself but rather something else. Any advice?
Michael
|
|
|