Front knuckle Lower ball joint taper [message #338222] |
Tue, 30 October 2018 11:59 |
skip2
Messages: 544 Registered: September 2011 Location: Winter Haven,FL (center o...
Karma:
|
Senior Member |
|
|
Just finished tightening up the nut and two bolts and nuts on my lower ball joints again, does anyone know if there was possibly a different taper between the auto and gmc knuckles. I'm asking because I installed the spare knuckles that came with my gmc when I bought it. It was first the right and once I got it tightened down the second time its been ok now the left loosened up. I got the new balljoints from Applied a few years ago so they should not be the problem. Anyone else have this problem. Oh, yes once I got it all tightened back up I lost about half my torque steer and it drove like it's suppose to. Thanks.
Skip Hartline
74 Canyon Lands, FiTech,
3.7 FD LSD, Manny Tranny,
Springfield Distributor,
2001 Chevy Tracker Ragtop Towd
|
|
|