| [GMCnet] One Ton Half shafts [message #337673] |
Sun, 07 October 2018 12:45  |
Dolph Santorine
Messages: 1236
Registered: April 2011
Location: Wheeling, WV
Karma: -41
|
Senior Member |
|
|
I’m looking for a part number for the half shafts for the one ton.
I’m getting a vibration, it’s not tires (I move them around and the vibration stays), and when I last replaced boots, I noticed some heat discoloration on the wheel side CV joint.
It also diminishes when coasting.
Other thoughts for diagnosis would be appreciated.
Dolph Santorine
Dolph@DolphSantorine.com
Excuse me for not being my usual wordy and sporadically verbose self. This message is sent from my iPhone.
No trees were killed in the sending of this message and few long dead dinosaurs were involved. A large number of electrons were terribly inconvenienced.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
| Re: [GMCnet] One Ton Half shafts [message #337676 is a reply to message #337673] |
Sun, 07 October 2018 14:32  |
 |
RF_Burns
Messages: 2277
Registered: June 2008
Location: S. Ontario, Canada
Karma: 3
|
Senior Member |
|
|
The one-ton half-shaft (axles) are not an off-the-shelf product. They were made for the kit (axle shafts themselves are custom). Call either Manny or JimK.
Bruce Hislop
ON Canada
77PB, 455 Dick P. rebuilt, DynamicEFI EBL EFI & ESC.
1 ton front end
http://www.gmcmhphotos.com/photos/showphoto.php?photo=29001
My Staff says I never listen to them, or something like that
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
