GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » Furnace Heater upgrade (install of Atwood 35K BTU heater and our curved surface)
Furnace Heater upgrade [message #336812] Fri, 07 September 2018 12:25 Go to previous message
Jack Ramsey is currently offline  Jack Ramsey   United States
Messages: 82
Registered: December 2012
Location: Tulare, CA
Karma:
Member
I am assuming I will need to build a sheetmetal v to fill in the sides and lip over the top, and keep the interior heater compartment free from CO by making sure the seals are good and airtight. Anyone else done this (I am sure many have)

http://www.gmcmhphotos.com/photos/ramsey-rebuild/p65177-heater-upgrade-atwood-excal-3500-afmd35111-a.html

http://www.gmcmhphotos.com/photos/ramsey-rebuild/p65175-heater-upgrade-atwood-excal-3500-afmd35111-a.html

http://www.gmcmhphotos.com/photos/ramsey-rebuild/p65178-service-end-of-heater.html

Jack Ramsey Tulare, CA TZE165V101526 1975 Palm Beach

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: House hot water heater issues
Next Topic: [GMCnet] New plastic gas tanks needed
Goto Forum:
  


Current Time: Tue Nov 05 05:04:09 CST 2024

Total time taken to generate the page: 0.00937 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software