GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.
Home » Public Forums » GMCnet » [GMCnet] porportion valve
[GMCnet] porportion valve [message #336255] Tue, 21 August 2018 17:33 Go to next message
Dean Hanson is currently offline  Dean Hanson   United States
Messages: 114
Registered: May 2018
Karma: 2
Senior Member
Had a rear wheel cylinder redone . I thot it was bled but when I picked it
up, the brake light was on. Can one 'reposition' the porportion valve on a
GMC?



Dean C. Hanson

75 Avion.



Fremont, Ca. 94536

(510) 657-9600



_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

Re: [GMCnet] porportion valve [message #336259 is a reply to message #336255] Tue, 21 August 2018 19:17 Go to previous message
tphipps is currently offline  tphipps   United States
Messages: 3005
Registered: August 2004
Location: Spanish Fort, AL
Karma: 9
Senior Member
Recheck or redo the bleeding procedure. You may have air trapped in the lines.
Does the plunger on the forward side of the proportion valve move? If it is the original iron assembly, it maybe internally rusted stuck.
Was the light on before you bleeded the brake lines? Did you check to see if the wire is still attached to the valve?
Lots of little things to double check.
Tom

2012 Phoenix Cruiser model 2552 KA4CSG

Report message to a moderator

Previous Topic: [GMCnet] Need a original buzz box.
Next Topic: [GMCnet] 1974 Sequoia - Rochester, NY - $19,500
Goto Forum:
  


Current Time: Tue Nov 19 19:22:57 CST 2024

Total time taken to generate the page: 0.00731 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.1.
Copyright ©2001-2021 FUDforum Bulletin Board Software