GMCforum: GMCnet » [GMCnet] Onan start switch that's on the engine. Doesn't work.

Home » Public Forums » GMCnet » [GMCnet] Onan start switch that's on the engine. Doesn't work.

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Onan start switch that's on the engine. Doesn't work. [message #334578]

Wed, 04 July 2018 10:37

BobDunahugh

Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA

Karma:

Senior Member

This is the Onan that I took out of the 78 that we use now. It was replaced by the Onan out of the burned 78. So I want to test run it to check it's condition. I pulled the circuit board out. Used a ohm meter to check the start switch. No continuity. Even tried a cleaner. I've identified the wire to the coil. What wire goes to the starter solenoid? What wires of the 4 that go to the remote start. Can I use? Don't mined buying a new board if it runs good. Bob Dunahugh 78 Royale Iowa
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]

		[GMCnet] Onan start switch that's on the engine. Doesn't work. By: BobDunahugh on Wed, 04 July 2018 10:37
		Re: [GMCnet] Onan start switch that's on the engine. Doesn't work. By: jhbridges on Wed, 04 July 2018 11:59
		Re: [GMCnet] Onan start switch that's on the engine. Doesn't work. By: Ken Burton on Wed, 04 July 2018 12:10
		Re: [GMCnet] Onan start switch that's on the engine. Doesn't work. By: BobDunahugh on Wed, 04 July 2018 16:22

Previous Topic:	On the Road Electrical Trouble-shooting
Next Topic:	[GMCnet] Steering box play

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Oct 01 03:07:26 CDT 2024

Total time taken to generate the page: 0.02934 seconds