GMCforum: GMCnet » [GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate.

Home » Public Forums » GMCnet » [GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate.

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate. [message #333505]

Thu, 14 June 2018 23:30

BobDunahugh

Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA

Karma:

Senior Member

I've heard for decades on how hard it is the get that brake cable out. Here's an extremely simple way to get it out. Get a 3/8" screw hose clamp. Put it around the brake cable housing. About 3/16" from the inside of the backing plate. Over the fingers that hold it in place. Screw the screw type hose down till the fingers are all folded in. Push the cable the 3/16" out the back of the backing plate till the hose clamp comes in contact with the backing plate. While pushing out on the cable. Remove hose clamp. Done with no damage to the cable. DONE. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

[Message index]

		[GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate. By: BobDunahugh on Thu, 14 June 2018 23:30
		Re: [GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate. By: Bullitthead on Fri, 15 June 2018 00:01
		Re: [GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate. By: jimk on Fri, 15 June 2018 00:04
		Re: [GMCnet] Tid Bit. Simple way to get park brack cable out of baking plate. By: Matt Colie on Fri, 15 June 2018 14:36

Previous Topic:	Mobil 1 on sale
Next Topic:	[GMCnet] Revelstoke

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Nov 05 12:59:33 CST 2024

Total time taken to generate the page: 0.00849 seconds