GMCforum: GMCnet » A Thank You to Jim Hupy about timing chain wear

Home » Public Forums » GMCnet » A Thank You to Jim Hupy about timing chain wear

Show: Today's Messages :: Polls :: Message Navigator

A Thank You to Jim Hupy about timing chain wear [message #330157]

Mon, 19 March 2018 10:59

Matt Colie

Messages: 8547
Registered: March 2007
Location: S.E. Michigan

Karma:

Senior Member

Jim,

When I mentioned how loose the timing chain of my engine was, you suggested that I look at the plug in the block face that is suppose to oil that.

Well, I unscrewed it and could not see though it. One little chip of carbon came out.

During my search for replacement valves, I am also going to work up a plan to put a crud catcher in that squirter. I don't currently have any idea what it is going to be, but I have lots of strange stuff to choose from. Very fine steel screen might be good. Like the stainer for a paint spray gun. I really don't know, but I can afford to do a lot of thinking.

Matt

Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit

Report message to a moderator

[Message index]

		A Thank You to Jim Hupy about timing chain wear By: Matt Colie on Mon, 19 March 2018 10:59
		Re: [GMCnet] A Thank You to Jim Hupy about timing chain wear By: James Hupy on Mon, 19 March 2018 11:16

Previous Topic:	[GMCnet] Semi single
Next Topic:	[GMCnet] Subject: Need names of who's inrersted in Futureliner tour at the September GMCMI Rally in Amana Iowa.

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Mar 12 11:36:56 CDT 2025

Total time taken to generate the page: 0.00662 seconds