Re: [GMCnet] Fuel system. [message #323719 is a reply to message #323715] |
Sun, 10 September 2017 17:05 |
johnd01
Messages: 354 Registered: July 2017 Location: Sacrameot
Karma:
|
Senior Member |
|
|
I have 2 inches of pipe coming from the fuel pump followed by 6 inches of
hose bridging a 2-inch gap in the tubing ending about an inch before the
bend to over the intake manifold. I have been told I need to replace the
line with a solid tube.
I have also been told to replace the clear plastic fuel filter just below
the pump.
Do I really need to?
On Sun, Sep 10, 2017 at 2:34 PM, Matt Colie wrote:
> johnd01 wrote on Sun, 10 September 2017 16:25
>> Thanks for the info. Next question is, do I go electric or replace with
> the
>> original? The 2 pump electric looks good in that there is some redundancy
>> but there is hose after the pump. Is that ok here but not in the front of
>> the engine? The open relay contacts are not wither proof.
>> --
>> *John Phillips*
>
> John,
>
> It will be nearly impossible to assemble a GMC fuel system with no rubber
> in the pressurized part of the system. The caution is to not have rubber on
> top of the engine where if it should leak, it can pool
> on top of the hot engine. If it leaks on the ground, nobody but the EPA
> and the gut that has to patch the McAdam will care.
>
> Matt
> --
> Matt & Mary Colie - '73 Glacier 23 - Members GMCMI, GMCGL, GMCES
> Electronically Controlled Quiet Engine Cooling Fan
> OE Rear Drum Brakes with Applied Control Arms
> SE Michigan - Twixt A2 and Detroit
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
--
*John Phillips*
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Johnd01
John Phillips
Avion A2600 TZE064V101164
Rancho Cordova, CA (Sacramento)
|
|
|