GMCforum: GMCnet » [GMCnet] Correct transmossion fluid level

Home » Public Forums » GMCnet » [GMCnet] Correct transmossion fluid level

Show: Today's Messages :: Polls :: Message Navigator

[GMCnet] Correct transmossion fluid level [message #320219]

Sun, 09 July 2017 13:25

BobDunahugh

Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA

Karma: 11

Senior Member

I've hard that some combinations of dip sticks/tubes end up wrong. Start your engine. And run for 2 minutes. Turn off. Use a 1/2" wrench to pull your trans vacuum modulator out. If there's too much fluid. It will drain out. Or add till the fluid comes out. Put modulator back in. See were the level is at. Start, and check level. At cold. Should be on add. It will go to full when hot. As I recall. This is correct. Speak up if I have any of this incorrect. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Report message to a moderator

Previous Topic:	Single front wheel rotor on rear hub?
Next Topic:	GMC's on the road

Goto Forum:

-=] Back to Top [=-

Current Time: Wed Nov 06 11:44:52 CST 2024

Total time taken to generate the page: 0.00516 seconds