GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Norcold issue
[GMCnet] Norcold issue [message #320111] Fri, 07 July 2017 15:57 Go to next message
w schurman is currently offline  w schurman   United States
Messages: 49
Registered: June 2015
Karma: 1
Member
I bought new a Norcold 2 door 3-way refrigerator approx 10 -12 years ago
(I've lost the sales slip) that has always performed without any issue. It
has three buttons, on/off; mode; and temp with a display for each. To start
the refrigerator I press "on"; the mode button and it cycles through the
three options and settles on the best available option. This past weekend
it would scan through the options but it would display "no com" without
selection one of three options. I was plugged into 120 (and power was 120
at the plug in for the refrigerator), the LP tank is half full; and the
house batteries fully charged. All of the connections have never been
touched since installed.
Thanks for any ideas as it's hot here in Colorado.

--
William S. Schurman
box 772806
Steamboat Springs, CO
80477
1978 Palm Beach
TZE168V100258
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Norcold issue [message #320114 is a reply to message #320111] Fri, 07 July 2017 16:09 Go to previous messageGo to next message
James Hupy is currently offline  James Hupy   United States
Messages: 6806
Registered: May 2010
Karma: -62
Senior Member
Your fridge also requires 12 volts DC, I believe. There should be an in
line fuse in the circuit. Check in the rear of your fridge for presence of
12 volts with a multitester or a 12 volt test lamp. If no voltage, trace
back to the source until you find the fuse holder. If fuse is blown, look
for obvious bare wires etc before replacing the fuse.
Jim Hupy

On Jul 7, 2017 1:58 PM, "w schurman" wrote:

> I bought new a Norcold 2 door 3-way refrigerator approx 10 -12 years ago
> (I've lost the sales slip) that has always performed without any issue. It
> has three buttons, on/off; mode; and temp with a display for each. To start
> the refrigerator I press "on"; the mode button and it cycles through the
> three options and settles on the best available option. This past weekend
> it would scan through the options but it would display "no com" without
> selection one of three options. I was plugged into 120 (and power was 120
> at the plug in for the refrigerator), the LP tank is half full; and the
> house batteries fully charged. All of the connections have never been
> touched since installed.
> Thanks for any ideas as it's hot here in Colorado.
>
> --
> William S. Schurman
> box 772806
> Steamboat Springs, CO
> 80477
> 1978 Palm Beach
> TZE168V100258
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Norcold issue [message #320122 is a reply to message #320114] Fri, 07 July 2017 17:53 Go to previous messageGo to next message
scott cowden is currently offline  scott cowden   United States
Messages: 170
Registered: February 2004
Karma: 0
Senior Member
With any older Norcold the first question that I would ask is the status of the recall on that appliance. Norcold has had major issues with fires and other things occurring that I would look to see whether or not it should be replaced or modified under that warranty Campaign prior to doing anything else to it.

Just the old fireman talking here, of course.

Scott
'74 x-Glacier
Orillia, ON
Canada


Sent from my iPhone

> On Jul 7, 2017, at 5:10 PM, James Hupy wrote:
>
> Your fridge also requires 12 volts DC, I believe. There should be an in
> line fuse in the circuit. Check in the rear of your fridge for presence of
> 12 volts with a multitester or a 12 volt test lamp. If no voltage, trace
> back to the source until you find the fuse holder. If fuse is blown, look
> for obvious bare wires etc before replacing the fuse.
> Jim Hupy
>
>> On Jul 7, 2017 1:58 PM, "w schurman" wrote:
>>
>> I bought new a Norcold 2 door 3-way refrigerator approx 10 -12 years ago
>> (I've lost the sales slip) that has always performed without any issue. It
>> has three buttons, on/off; mode; and temp with a display for each. To start
>> the refrigerator I press "on"; the mode button and it cycles through the
>> three options and settles on the best available option. This past weekend
>> it would scan through the options but it would display "no com" without
>> selection one of three options. I was plugged into 120 (and power was 120
>> at the plug in for the refrigerator), the LP tank is half full; and the
>> house batteries fully charged. All of the connections have never been
>> touched since installed.
>> Thanks for any ideas as it's hot here in Colorado.
>>
>> --
>> William S. Schurman
>> box 772806
>> Steamboat Springs, CO
>> 80477
>> 1978 Palm Beach
>> TZE168V100258
>> _______________________________________________
>> GMCnet mailing list
>> Unsubscribe or Change List Options:
>> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Norcold issue [message #320128 is a reply to message #320111] Fri, 07 July 2017 18:53 Go to previous message
WCB75 is currently offline  WCB75   Canada
Messages: 42
Registered: May 2015
Location: Tampa,Florida
Karma: 0
Member
No com sounds like you've lost communication from the front board to the back board... first thing I'd look into is the connectors between them.. moisture can cause communication issues on these connectors..

Hope that helps..



Bill and Mary Kay Boeyen 76 23' Birchaven 455 Tampa, Florida
Previous Topic: New microwave/convection oven
Next Topic: Correct AC compressor
Goto Forum:
  


Current Time: Thu Nov 07 13:43:34 CST 2024

Total time taken to generate the page: 0.00994 seconds