| Onan [message #319421] |
Wed, 21 June 2017 20:11  |
Bill Shourt
Messages: 33
Registered: January 2005
Location: Sherman Oaks ,Ca
Karma:
|
Member |
|
|
About five percent of the time when I start the Onan the starter will stay engaged. If i pull connector on the solenoid the starter shuts off and if I re connect the wire the starter doesn't start again. I have a new dino board and new Onan starter relay from Jim K. I think that I must have a high resistance connection somewhere. I have cleaned the multi pin connector where the board hooks up to the Onan wiring harness. and the connection at the disconnected voltage regulator. when I meter across the connector on # 8 and # 11 I get .1 ohm with a Fluke meter. are there any other connectors between the flywheel alt and the 8-11 pins on the board? any other ideas ?
It was doing the same thing before I replaced the board and the K1 relay but much more frequently. I bought a door bell transformer but I would love to keep it stock. HELP its driving me crazy.
Bill and Michele Shourt
78 Kingsley, origional
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
