GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Ev6010
[GMCnet] Ev6010 [message #317937] Tue, 23 May 2017 18:17 Go to next message
Advanced Concept Ener is currently offline  Advanced Concept Ener   United States
Messages: 112
Registered: December 2014
Karma: 0
Senior Member
The 6010 noise is a higher frequency than the Onan. Higher frequencies are easier to attenuate than the low frequency hum from the Onan. You need lots of heavy mass like lead and Sheetrock to absorb low frequency energy. So properly insulated you can make the Honda much quieter than the Onan . I have had then both and my Honda is much quieter. It also help to be deaf to higher frequencies! With all the the self help videos and Paul's support at Pinellas I'll take the Honda every time. I think $1200 on a unit with less than 300 hours is a bargain.

Jon Darcy ACES
North Jersey 76 stretch, flares, 4 bag, Alcoa's, bunkhouse,MAC Dash,Manny Trans, FiTech FI,Honda 6010

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Ev6010 [message #317969 is a reply to message #317937] Wed, 24 May 2017 10:41 Go to previous messageGo to next message
Justin Brady is currently offline  Justin Brady   United States
Messages: 769
Registered: April 2015
Location: Bell Buckle, TN
Karma: 11
Senior Member
For the record these are exactly the comments that I'm talking about Very Happy
With the onan running correctly with a good exhaust and no leaks, you can stand beside it and carry on a conversation.
The Honda, not so much.

I have run both side by side in the shop.

Inside the coach is a different story than outside, I've got 4 layers of sound deadening material, 4" of spray foam, and a 10" memory foam mattress between me and the genset, it's OK inside.
Outside though I am very self conscious about running it when there are other people within a couple hundred yards. Sounds like someone is mowing the lawn at 90 mph Laughing

You do make a point about not hearing high frequencies, I can't hear above 10khz. Maybe you guys who are twice my age can't hear above 5khz and that's why everyone says it's quiet haha!


Justin Brady http://www.thegmcrv.com/ 1976 Palm Beach 455

[Updated on: Wed, 24 May 2017 10:42]

Report message to a moderator

Re: [GMCnet] Ev6010 [message #317971 is a reply to message #317937] Wed, 24 May 2017 11:01 Go to previous messageGo to next message
jknezek is currently offline  jknezek   United States
Messages: 1057
Registered: December 2007
Karma: 5
Senior Member
Could just be a matter of perspective then. For my purposes, the Honda is quieter. We use the generator going down the road and that's about it. So I don't care if it is louder outside. I do care if it is louder inside, and it's not. Plus it does something my Onan, despite a ton of time and money, failed to do. Start consistently when needed. So I'm probably a little more forgiving of the sound, which I do agree is a much higher pitched and irritating noise if you are standing next to the units running side by side outside.

Thanks,
Jeremy Knezek
1976 Glenbrook
Birmingham, AL
Re: [GMCnet] Ev6010 [message #317972 is a reply to message #317971] Wed, 24 May 2017 11:15 Go to previous messageGo to next message
Dolph Santorine is currently offline  Dolph Santorine   United States
Messages: 1236
Registered: April 2011
Location: Wheeling, WV
Karma: -41
Senior Member
With all the quiet inverter units out there right now, has anyone done anything about fitting them to a coach?

We picked up a 3kW inverter Honda for our real estate biz. It's incredibly quiet.

Dolph Santorine

DE AD0LF

Wheeling, West Virginia

1977 ex-Palm Beach TZE167V100820
1-ton, Sullybuilt Bags, Reaction Arms, 3.70 LSD, Manny Transmission, EV-6010,


> On May 24, 2017, at 12:01 PM, Jeremy wrote:
>
> Could just be a matter of perspective then. For my purposes, the Honda is quieter. We use the generator going down the road and that's about it. So I
> don't care if it is louder outside. I do care if it is louder inside, and it's not. Plus it does something my Onan, despite a ton of time and money,
> failed to do. Start consistently when needed. So I'm probably a little more forgiving of the sound, which I do agree is a much higher pitched and
> irritating noise if you are standing next to the units running side by side outside.
> --
> Thanks,
> Jeremy Knezek
> 1976 Glenbrook
> Birmingham, AL
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org


_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Ev6010 [message #317974 is a reply to message #317937] Wed, 24 May 2017 11:26 Go to previous messageGo to next message
jknezek is currently offline  jknezek   United States
Messages: 1057
Registered: December 2007
Karma: 5
Senior Member
I know JimB worked on this for a while a few years back. There were problems with picking up the heavy start up load for things like AC units. Perhaps the tech has progressed to where this is more feasible now.

Thanks,
Jeremy Knezek
1976 Glenbrook
Birmingham, AL
Re: [GMCnet] Ev6010 [message #317978 is a reply to message #317974] Wed, 24 May 2017 12:07 Go to previous messageGo to next message
Dolph Santorine is currently offline  Dolph Santorine   United States
Messages: 1236
Registered: April 2011
Location: Wheeling, WV
Karma: -41
Senior Member
I just starting looking into this, and they rate the sound level at dB-A weighted at 23 feet?

Specsmanship from the marketing department at it’s finest. Simply amazing.

Kind of like how tight should that fastner be? One grunt or two?

Furlongs per Fortnight.


Dolph

DE AD0LF

Wheeling, West Virginia

1977 26’ ex-PalmBeach
1-Ton, Sullybilt Bags, Reaction Arms, 3.70 LSD, Manny Transmission, EV-6010

“The Aluminum and Fiberglass Mistress"

> On May 24, 2017, at 12:26 PM, Jeremy wrote:
>
> I know JimB worked on this for a while a few years back. There were problems with picking up the heavy start up load for things like AC units. Perhaps
> the tech has progressed to where this is more feasible now.
> --
> Thanks,
> Jeremy Knezek
> 1976 Glenbrook
> Birmingham, AL
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Re: [GMCnet] Ev6010 [message #317979 is a reply to message #317937] Wed, 24 May 2017 12:13 Go to previous messageGo to next message
rcjordan   United States
Messages: 1913
Registered: October 2012
Location: Elizabeth City, North Car...
Karma: 1
Senior Member
There is a thread here somewhere showing a 23' with a Honda EU3000i in the bay. It physically fits, even in a 23' narrow bay, but we never did hear if it had been permanently installed or was just sitting on the tray. I suspect it was the later.

I have a EU3000i for the house, it is incredibly quiet.


SOLD 77 Royale Coachmen Side Dry Bath
76 Birchaven Coachmen Side Wet Bath
76 Eleganza
Elizabeth City, NC
Re: [GMCnet] Ev6010 [message #317980 is a reply to message #317937] Wed, 24 May 2017 13:10 Go to previous message
rcjordan   United States
Messages: 1913
Registered: October 2012
Location: Elizabeth City, North Car...
Karma: 1
Senior Member
Dolph, the old EU3000 thread is here:

http://gmc.mybirdfeeder.net/GMCforum/index.php?t=msg&th=33336&goto=271658&rid=0

The ebay links with the pics still work.


SOLD 77 Royale Coachmen Side Dry Bath
76 Birchaven Coachmen Side Wet Bath
76 Eleganza
Elizabeth City, NC
Previous Topic: [GMCnet] new fuses
Next Topic: [GMCnet] White knuckle ride
Goto Forum:
  


Current Time: Fri Nov 15 15:09:37 CST 2024

Total time taken to generate the page: 0.01647 seconds