|
|
|
|
Re: [GMCnet] How to measure for accurate hole drilling? [message #317489 is a reply to message #317440] |
Fri, 12 May 2017 22:58 |
GMC Cruse
Messages: 606 Registered: June 2009 Location: SE Michigan
Karma: 3
|
Senior Member |
|
|
Michael Bozardt wrote on Fri, 12 May 2017 11:07AH-SO, I am trying dowels but takes much time to whittle down to size. Good news is if works, I can use them on lower panel as well.
An easier way might be to make a template of the cover out of thin cardboard, tape it in place and tap the area of the holes lightly a number of times with a small ballpein hammer. On the backside of the cardboard will be circle marks of the holes. Most times you are even able to punch out the hole completely like a paper punch would with the hammer. Lay the template over your cover and drill the holes in the cover.
Mike K.
'75 PB
Southeast Michigan
|
|
|
|
|
|
Re: [GMCnet] How to measure for accurate hole drilling? [message #318142 is a reply to message #318139] |
Mon, 29 May 2017 11:54 |
James Hupy
Messages: 6806 Registered: May 2010
Karma: -62
|
Senior Member |
|
|
If there are existing screw holes in the door itself, and I am using a
fabric covering, I use a needle pointed scribe and pierce the fabric and
probe the existing holes. If I am using a rigid faced panel, I use trim
screws with a washer head to secure the panel. Sometimes called by other
names, but they incorporate a stainless or Chrome plated brass washer under
the screw head. Fairly forgiving, you can use a bit larger hole and align
the panel with the edge of the door. On my own coach, I used Naugahyde to
cover the door. Sheds water very well, and scuff resistant. Not dog claw
proof however.
Jim Hupy
Salem, Or
78 GMC ROYALE 403
On May 29, 2017 9:42 AM, "Michael Bozardt" wrote:
> Phase II - - I tried dowels, that did not work. Next, paint pencil around
> the holes, that did not work.
> Finally, used the Dremel tool with a very small point on a little grinding
> bit. Was able to get close enough or centered in the hole to enlarge the
> small hole enough for the screws to fit. Top panel hung and will hang the
> lower panel on the door today.
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|