Re: [GMCnet] How to measure for accurate hole drilling? [message #317247 is a reply to message #317245] |
Tue, 09 May 2017 08:34 |
Mike Kelley
Messages: 467 Registered: February 2017
Karma:
|
Senior Member |
|
|
Larry Hopkins:
Hey Man - would you be interested in joining the GMC 6 Wheelers? We do 6 rally's per yr from May thru Oct. Our area is a 200 mile range from Chicago - most members are from IL. & Ind. We are a small club - about 34 paid members and usually 8 to 12 coaches per rally.
$10.00 membership fee per yr - best deal in town!!!
Thanks for your response.
Mike Kelley
GMC 6 Wheeler President
Also known as "The Corvair a holic"
Sent from my iPhone
> On May 9, 2017, at 7:59 AM, Matt Colie wrote:
>
> I actually have several sets of "transfers". Some for plain holes in wood - as these are rarely tapped. Another is a box of sharp pointed screws
> that I seem to misplace regularly. I did have them when I put the new cover on the door, but I didn't have enough for all two dozen screws at once.
> So I elected to do the top first. And I didn't notice that the plastic had slipped......
> So, I drilled all the holes right on the mark only to find that the panel didn't with the screws in place.
> That is why you can see the double holes in the top edge.
> I'll either cover the panel or make a new one when I have nothing else to do for the house, cars, yard and coach.
>
> Matt
> --
> Matt & Mary Colie - '73 Glacier 23 - Members GMCMI, GMCGL, GMCES
> Still Loving OE Rear Drum Brakes with Applied Control Arms
> SE Michigan - Twixt A2 and Detroit
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|