Rear bed dimensions [message #317107] |
Fri, 05 May 2017 10:17 |
GeorgeRud
Messages: 1380 Registered: February 2007 Location: Chicago, IL
Karma: 0
|
Senior Member |
|
|
My '75 Palm Beach has the rear dinette that converts to a bed. Does anyone have the dimensions of the back area when it's converted to the bed? I have a strange sized mattress from an oversized hospital bed that might fit, but I don't have my coach at home to check on the dimensions.
Thanks in advance for your help.
George Rudawsky
Chicago, IL
75 Palm Beach
|
|
|
Re: [GMCnet] Rear bed dimensions [message #317108 is a reply to message #317107] |
Fri, 05 May 2017 10:37 |
RicksGMC
Messages: 145 Registered: May 2012
Karma: 0
|
Senior Member |
|
|
The permanent bed that I'm building in the back is 54"x80", if that helps.
Rick
Rick&Tammy Drummond
Prior Lake MN
'74 (re)Painted Desert
> On May 5, 2017, at 10:17 AM, George Rudawsky wrote:
>
> My '75 Palm Beach has the rear dinette that converts to a bed. Does anyone have the dimensions of the back area when it's converted to the bed? I
> have a strange sized mattress from an oversized hospital bed that might fit, but I don't have my coach at home to check on the dimensions.
>
> Thanks in advance for your help.
> --
> George Rudawsky
> Chicago, IL
> 75 Palm Beach
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
Rick
Rick&Tammy Drummond
Prior Lake MN
'74 (re)Painted Desert
|
|
|
Re: Rear bed dimensions [message #317109 is a reply to message #317107] |
Fri, 05 May 2017 11:05 |
A Hamilto
Messages: 4508 Registered: April 2011
Karma: 39
|
Senior Member |
|
|
GeorgeRud wrote on Fri, 05 May 2017 10:17My '75 Palm Beach has the rear dinette that converts to a bed. Does anyone have the dimensions of the back area when it's converted to the bed? I have a strange sized mattress from an oversized hospital bed that might fit, but I don't have my coach at home to check on the dimensions.
Thanks in advance for your help. The dinette converts to a standard double bed. 54" wide and 74" long. The seats are 48" wide, the 6" bolster makes it 54". Each seat, when folded down is 37", two if which makes 74". My '73 has a "clothes hamper" built over the propane compartment. If that is removed, it would make room for what is called a "double XL" which, as a previous post mentioned, is 54" wide by 80" long. The space might be a little longer, but the double and double XL are the sizes of sheet sets that are common.
|
|
|
Re: Rear bed dimensions [message #317112 is a reply to message #317107] |
Fri, 05 May 2017 12:11 |
Scott Nutter
Messages: 782 Registered: January 2015 Location: Houston/San Diego
Karma: 4
|
Senior Member |
|
|
George,
What I did was to take my coach to a local mattress factory, and had them take the measurements. There is a bit of custom cut in the very rear to fit it between the tail lights so you don't roll into the void. just a couple of inches, but it does make a difference.
These new foam mattresses are very comfortable, around $500.
Good luck! Scott
Scott Nutter
1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI
Houston, Texas
|
|
|
|
|
|
Re: [GMCnet] Rear bed dimensions [message #317133 is a reply to message #317132] |
Sat, 06 May 2017 12:17 |
Mike Kelley
Messages: 467 Registered: February 2017
Karma: -2
|
Senior Member |
|
|
George Rudawsky:
R U a member of a GMC Motorhome club? If not, the GMC 6 Wheelers would like to invite you to join us.
Our area is a 200 mile radius from Chicago and we do 6 rallies per year (May thru Oct) and usually the third weekend of the month.
We are a smaller GMC club than most and are pretty laid back - we have two business meetings per year and they are held during our rallies (usually May and Oct).
Let me know if you are interested.
Mike Kelley
GMC 6 Wheeler President
Sent from my iPhone
> On May 6, 2017, at 10:45 AM, George Rudawsky wrote:
>
> Thanks for all the replies! It helped a lot.
> --
> George Rudawsky
> Chicago, IL
> 75 Palm Beach
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|