GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Distributor o-ring (not present HEI?)
Distributor o-ring [message #314003] Fri, 03 March 2017 07:04 Go to previous message
Tilerpep is currently offline  Tilerpep   United States
Messages: 404
Registered: June 2013
Location: Raleigh, NC
Karma:
Senior Member
I pulled the distributor on the 78 Royale, and it did not have an oring where it sits in the engine. The way I read the parts book, p.7-16 and 7-18, the old style had an o-ring and the HEI did not. The one I pulled out was VERY stuck/gunked in (I used a steady pull from above with a ratchet strap on the gantry I built to pull the intake manifold, and then tapped with a rubber mallet for nearly half hour. lots of PB blaster). Should I grease and re-install with no o-ring?

1975 Glenbrook, 1978 Royale rear bath Raleigh, NC
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Inverter location and installation help
Next Topic: [GMCnet] Good water heater tank, and headliner for sale. Can bring to Shawnee.
Goto Forum:
  


Current Time: Sat Nov 16 19:37:10 CST 2024

Total time taken to generate the page: 0.01138 seconds