Propane Tank Hold Down [message #313252] |
Wed, 15 February 2017 12:37 |
A Hamilto
Messages: 4508 Registered: April 2011
Karma:
|
Senior Member |
|
|
A PO removed the OEM tank and installed a gas grill tank fitting on the regulator. I have the OEM tank and need to re-install it in the Sequoia.
I don't have any of the mounting hardware.
Is there supposed to be anything under/on top of the plywood to span body framing members, or fender washers on the bottom or what?
Carriage bolts?
I can't tell anything from the CanyonLands, as a PO removed the OEM propane tank from it as well. I can cannibalize the regulator and any other gas plumbing stuff I need from it, but there are only 4 holes in the bottom of the compartment to hint at what was originally there.
If there is some kind of bracket/hardware above or below the plywood, pictures would be greatly appreciated.
|
|
|