| [GMCnet] LP tank sending unit has no continuity [message #312658] |
Mon, 30 January 2017 22:00  |
BobDunahugh
Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA
Karma: 11
|
Senior Member |
|
|
I have a white ground wire that goes to one of the four screws that hold the gauge unit in the tank. A red wire that goes to the terminal. And have no continuity between them. ( this is a Royale ) So I think the sender has passed on. I think I was told that I need another ground wire. Remember. I'm no sparky. I had to take a cabinet out to get to this. I'm not happy. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
| Re: [GMCnet] LP tank sending unit has no continuity [message #312666 is a reply to message #312658] |
Tue, 31 January 2017 04:07  |
 |
wally
Messages: 643
Registered: August 2004
Location: Omaha Nebraska
Karma: 5
|
Senior Member |
|
|
BobDunahugh wrote on Mon, 30 January 2017 22:00I have a white ground wire that goes to one of the four screws that hold the gauge unit in the tank. A red wire that goes to the terminal. And have no continuity between them. ( this is a Royale ) So I think the sender has passed on. I think I was told that I need another ground wire. Remember. I'm no sparky. I had to take a cabinet out to get to this. I'm not happy. Bob Dunahugh
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
You might try removing just the plastic part with the dial from the body. The back of it has a metal point that is supposed to make contact with the metal body. Ours had a little corrosion there and worked again after scuffing with scotch brite.
Wally Anderson
Omaha NE
75 Glenbrook
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
