|
|
|
Re: flange seal removal... quick question [message #312227 is a reply to message #312214] |
Tue, 17 January 2017 18:26 |
|
Matt Colie
Messages: 8547 Registered: March 2007 Location: S.E. Michigan
Karma: 7
|
Senior Member |
|
|
GMC Jimmy wrote on Tue, 17 January 2017 14:35Hello All, just a quick question regarding the flange seal removal... I removed the toilet (Thetford Aurora) and would like to remove the flange in order to replace it before the new flooring goes in.
I've tried to pull and pry, gently, to no avail, is there a trick to this or do I simply apply more pressure and it pop's right out?
If there is a trick like spraying some silicone or other idea before I break something please let me know?
http://www.gmcmhphotos.com/photos/my-75-royale/p62060-flange-seal-1.html
Thanks again,
Mike
Mike,
I did a custom wrench too, but it was two 1/4 inch screws pushed into holes in a 2X4. Then I had to band saw the ends off the 2X4 because the piece picked off the stack was too long to swing in the space by about 1-1/2".
Matt
Matt & Mary Colie - Chaumière -'73 Glacier 23 - Members GMCMI, GMCGL, GMCES
Electronically Controlled Quiet Engine Cooling Fan with OE Rear Drum Brakes with Applied Control Arms
SE Michigan - Near DTW - Twixt A2 and Detroit
|
|
|
|