| [GMCnet] Power steering pulley removal [message #308922] |
Mon, 17 October 2016 18:26  |
Advanced Concept Ener
Messages: 112
Registered: December 2014
Karma:
|
Senior Member |
|
|
No luck yet!
On page 9-2 figure 1 of x-7725 it shows a nut on the shaft. Pretty confusing. I put split puller on indent of pulley hub and tightened down as hard as I can. Hit shaft of puller with hammer. All I did was round out the Allen wrench fitting and started to bend metal around hole where I stuck a wrench to stop shaft from rotating. No movement at all. I guess I can put. A socket on the puller shaft tomorrow and use the impact wrench. Hardened shaft will either splinter, totally ruin the nut ?? Or get the pulley to pop off. Does anyone know where I can buy replacement pulley as I may need it?
Jon Darcy ACES
North Jersey 76 stretch, flares, 4 bag, Alcoa's, bunkhouse,MAC Dash,Manny Trans, FiTech FI,Honda 6010
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
