GMCforum: GMCnet » Broken shock attachment

Home » Public Forums » GMCnet » Broken shock attachment - lower control arm (Repair or replace)

Show: Today's Messages :: Polls :: Message Navigator

Broken shock attachment - lower control arm [message #303298]

Fri, 08 July 2016 17:03

Jim Schulte

Messages: 9
Registered: January 2016
Location: Strawberry Point, IA

Karma: 0

Junior Member

In preparation to replace shocks observed the lower attachment bolt (right front) had been broken from the right lower control arm then was tack welded (by PO) to the control arm and the weld had broken. Should the control arm be replaced or taken off and to a welding shop. Jim

1977 Birchaven 455 133,000 mi

Report message to a moderator

Re: [GMCnet] Broken shock attachment - lower control arm [message #303300 is a reply to message #303298]

Fri, 08 July 2016 17:08

jimk

Messages: 6734
Registered: July 2006
Location: Belmont, CA

Karma: 9

Senior Member

That part should be replaced by cutting the rivet and a good used one be
bolted on.

On Fri, Jul 8, 2016 at 3:03 PM, James Schulte
wrote:

> In preparation to replace shocks observed the lower attachment bolt (right
> front) had been broken from the right lower control arm then was tack
> welded (by PO) to the control arm and the weld had broken. Should the
> control arm be replaced or taken off and to a welding shop. Jim
>
> 1977 Birchaven 455 133,000 mi
>
> _______________________________________________
> GMCnet mailing list
> Unsubscribe or Change List Options:
> http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
>

--
Jim Kanomata
Applied/GMC, Fremont,CA
jimk@appliedairfilters.com
http://www.appliedgmc.com
1-800-752-7502
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Jim Kanomata
Applied/GMC
jimk@appliedairfilters.com
www.appliedgmc.com
1-800-752-7502

Report message to a moderator

Re: [GMCnet] Broken shock attachment - lower control arm [message #303301 is a reply to message #303300]

Fri, 08 July 2016 18:40

Ken Burton

Messages: 10030
Registered: January 2004
Location: Hebron, Indiana

Karma: 10

Senior Member

It depends on where it is broken. Mine was broken about 10 years ago and I welded it back on. There is no need to remove it for welding. Just remove the shock and drive it to a welder.

You might need to remove the front tire to make room for the welder to work. I do not remember if I removed the tire or not. I do remember that it was a simple couple of minutes job to weld it back in place.

Ken Burton - N9KB
76 Palm Beach
Hebron, Indiana

Report message to a moderator

Previous Topic:	Parts Book PDF
Next Topic:	Onan free

Goto Forum:

-=] Back to Top [=-

Current Time: Sat Nov 16 04:04:40 CST 2024

Total time taken to generate the page: 0.00950 seconds