| [GMCnet] Reaction Arm Install [message #302997] |
Sun, 03 July 2016 14:08 |
Thomas Pryor
Messages: 143
Registered: January 2011
Karma: 1
|
Senior Member |
|
|
JOHNNY, I'M HERE TO HELP!
As we discussed I will be sending you the tooling with 5/8 SAE GR 8 bolt
and a GR 8 Nut welded to it for push out of your spindle. You will thread
the back side of the 4 spindle holes in your OEM spindle carrier with a
7/16" -14 National course tap. Do not drill the hole for the
Tap........the 4 holes in our spindle carrier are "correct enough" to hold
the plate in position while you run the 5/8 SAE bolt to finesse the spindle
out. As I told you heat up the spindle carrier.......it helps.
I used a single 1/2" CRS plate to remove four spindles from my abandoned
coach. Yours will be fresh!
--
Regards,
Tom Pryor
4188 Limerick Dr
Lake Wales, Fl 33859
Cell 248 470 9186
Living on a waterfront is not a matter of life or death. Its more
important than that.
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
