[GMCnet] FW: Huber torsion Bars-Price correction! [message #299415] |
Thu, 21 April 2016 13:49 |
p.huber
Messages: 73 Registered: June 2012 Location: Oakland
Karma: 3
|
Member |
|
|
Please take note:
Unfortunately the prices went up for the Huber Torsion Bar. It will cost now
$ 850.00 plus $ 50.00 Freight or $ 900.00 delivered plus Sales tax for
California orders.
This is the best price I could get, if I order again another batch the price
will go up even further. These Torsion Bars are difficult to make.
If you need a set of new Torsion Bars make your commitment now, while the
price is still low.
Thank you
Best regards
Peter D. Huber
From: Peter [mailto:a1huber@prodigy.net]
Sent: Sunday, April 17, 2016 5:52 PM
To: 'gmclist@list.gmcnet.org'
Subject: Huber torsion Bars!
If there is still an interest in the Huber torsion Bar with 1" extension of
the hex to go into the lower Control Arm please let me know. The old torsion
bars are slowly wearing out after 40 or more years. I supplied more than 75
sets of this new torsion bars and everybody seems to be very happy with
them! I have some committed interests already but need at least 15 sets (to
get a good price) of orders committed. I could put a batch together and it
will cost approximately $ 850.00 delivered to you place. It will take
approximately 2 month to do the transaction.
So if you are interested in the new torsion bars please contact me directly
and make your firm commitment with your deposit. Contact me at:
a1huber@prodigy.net. Thank you.
Best regard
Peter D. Huber
8190 Surrey Lane, Oakland, CA 94605
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org
|
|
|