| Applied Intake Gasket thoughts [message #296042] |
Tue, 23 February 2016 15:35  |
dr.diesel
Messages: 85
Registered: April 2015
Location: The Haute, Indiana
Karma:
|
Member |
|
|
So I bought the Applied 455 Intake gasket set with the stainless block off plates. All I received is the two gaskets and stainless inserts, no end gaskets and no basic instructions. As I've done about a zillion intake gaskets before I didn't think much of it till I read a few messages specifically mentioning them, then thought well heck I didn't get any, ha ha.
I'm assuming standard procedure?
- Thoroughly clean
- Use something like Permatex high tack sealant to glue gaskets to heads
- Use bead of RTV for end gaskets
- Try hard to not drop zillion pound intake during placement
- Torque bolt in proper order to 25lbs (just guessing need to look up torque)
- Celebrate with cold beer
Anything I'm missing, or special for the stainless inserts?
Many thanks
77 Kingsley
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
