GMCforum: GMCnet » GMC tool

Home » Public Forums » GMCnet » GMC tool

Show: Today's Messages :: Polls :: Message Navigator

GMC tool [message #294247]

Sat, 23 January 2016 17:27

jhbridges

Messages: 8412
Registered: May 2011
Location: Braselton ga

Karma:

Senior Member

I was in the local Aldi grocery store a couple hours ago, and on the housewares shelf they had a heathen chinee oscillating tool for 13 scoots, so I bought one. Trade name is Workzone. 6 bux less than HF, and it looks about the same. Time will tell.

--johnny

Foolish Carriage, 76 26' Eleganza(?) with beaucoup mods and add - ons. Braselton, Ga. I forgive them all, save those who hurt the dogs. They must answer to me in hell

Report message to a moderator

[Message index]

		GMC tool By: jhbridges on Sat, 23 January 2016 17:27
		Re: GMC tool By: rcjordan on Sat, 23 January 2016 18:22
		Re: [GMCnet] GMC tool By: USAussie on Sat, 23 January 2016 18:59
		Re: GMC tool By: jhbridges on Sat, 23 January 2016 20:19
		Re: [GMCnet] GMC tool By: USAussie on Sat, 23 January 2016 22:38
		Re: GMC tool By: thainglo on Sat, 23 January 2016 20:52
		Re: [GMCnet] GMC tool By: USAussie on Sat, 23 January 2016 22:36
		Re: [GMCnet] GMC tool By: Terry Taylor on Sun, 24 January 2016 11:15
		Re: [GMCnet] GMC tool By: USAussie on Sun, 24 January 2016 13:33
		Re: [GMCnet] GMC tool By: Matt Colie on Mon, 25 January 2016 09:38
		Re: GMC tool By: rcjordan on Sat, 23 January 2016 21:06
		Re: [GMCnet] GMC tool By: Mr ERFisher on Sun, 24 January 2016 04:33
		Re: [GMCnet] GMC tool By: USAussie on Sun, 24 January 2016 06:41
		Re: GMC tool By: jhbridges on Sun, 24 January 2016 08:34

Previous Topic:	Fixing the Sloppy Tilt Column
Next Topic:	Looking for DuoTherm furnace motor

Goto Forum:

-=] Back to Top [=-

Current Time: Tue Oct 01 10:33:25 CDT 2024

Total time taken to generate the page: 0.01240 seconds