GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » [GMCnet] Restoration. Fixing those little paint chips. And not have it show.
[GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293492] Wed, 06 January 2016 23:53 Go to next message
BobDunahugh is currently offline  BobDunahugh   United States
Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA
Karma: 11
Senior Member
Pick up a matching single stage paint that isn't lacquer based. ( Dries too quickly. ) Get a very tiny brush from a hobby store. Also some naptha. Don't thin the paint. As you want the paint to have some body to it. As you don't want the paint to flow out of the chip. Place small amount of paint in the chip so that the paint sticks up above the surface you're fixing. Let that fresh paint set up for about 15 minutes. Temp/ humidity will affect the wait time. Get a small part of a paper towel very wet with naptha. Gently, and slowly whip the fresh paint so that the thinner will dissolve the high points away first. The key is to let the thinner soften the highest point first. It's kind of like sanding off the high spots. With some practice, and care. The chip will be completely gone with no signs the it was ever there.Bob Dunahugh78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293511 is a reply to message #293492] Thu, 07 January 2016 10:44 Go to previous messageGo to next message
bhayes is currently offline  bhayes   United States
Messages: 263
Registered: March 2010
Karma: 1
Senior Member
Great tip! Thanks, Bob!

Bryan Hayes
'76 Eleganza II
Salt Lake City, Utah
Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293523 is a reply to message #293492] Thu, 07 January 2016 19:54 Go to previous messageGo to next message
KB is currently offline  KB   United States
Messages: 1262
Registered: September 2009
Karma: 0
Senior Member
ok, dumb question: do you mix the activator with the single stage paint first? Or just use the paint straight out of the can? I've noticed the single stage will set up eventually even without the activator, just takes longer and I'm guessing will not be as durable.

thanks,
Karen
1975 26'


BobDunahugh wrote on Wed, 06 January 2016 21:53
Pick up a matching single stage paint that isn't lacquer based. ( Dries too quickly. ) Get a very tiny brush from a hobby store. Also some naptha. Don't thin the paint. As you want the paint to have some body to it. As you don't want the paint to flow out of the chip. Place small amount of paint in the chip so that the paint sticks up above the surface you're fixing. Let that fresh paint set up for about 15 minutes. Temp/ humidity will affect the wait time. Get a small part of a paper towel very wet with naptha. Gently, and slowly whip the fresh paint so that the thinner will dissolve the high points away first. The key is to let the thinner soften the highest point first. It's kind of like sanding off the high spots. With some practice, and care. The chip will be completely gone with no signs the it was ever there.Bob Dunahugh78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org


Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293524 is a reply to message #293492] Thu, 07 January 2016 20:09 Go to previous messageGo to next message
kerry pinkerton is currently offline  kerry pinkerton   United States
Messages: 2565
Registered: July 2012
Location: Harvest, Al
Karma: 15
Senior Member
Because the paint won't ever get hard enough to wet sand without the hardener. I did about the same approach when I freshened our paint year before last:

http://gmc.mybirdfeeder.net/GMCforum/index.php?t=msg&goto=261900&rid=2555&srch=Paint+repair#msg_261900

I used primer to fill the dings and then painted over it. I could have done like Bob described and just built up the color. I used Acrylic enamel with hardener. When you add hardener to acrylic enamel it becomes urethane but costs less. Either will work fine.

I'm not sure you can even get hardened paint products on the left coast any more. I have no idea how to use waterborne products.


Kerry Pinkerton - North Alabama Had 5 over the years. Currently have a '06 Fleetwood Discovery 39L
Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293527 is a reply to message #293492] Fri, 08 January 2016 00:25 Go to previous messageGo to next message
BobDunahugh is currently offline  BobDunahugh   United States
Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA
Karma: 11
Senior Member

I used non hardened acrylic. Since I didn't put any thinner in the paint. It got hard enough, that I could work it down with the paper towel with thinner on the towel in about 15 minutes. And get the surface flat, and smooth. As to durability. I was only doing chips, and small scratches. It'll look great for along time. If you want. Put in some hardener.


Bob Dunahugh78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293531 is a reply to message #293527] Fri, 08 January 2016 07:48 Go to previous messageGo to next message
thesmith is currently offline  thesmith   United States
Messages: 589
Registered: February 2015
Location: Cary, NC
Karma: 6
Senior Member
Bob, what brand of paint did you use?


Pete


PS love the restoration reports.



BobDunahugh wrote on Fri, 08 January 2016 01:25

I used non hardened acrylic. Since I didn't put any thinner in the paint. It got hard enough, that I could work it down with the paper towel with thinner on the towel in about 15 minutes. And get the surface flat, and smooth. As to durability. I was only doing chips, and small scratches. It'll look great for along time. If you want. Put in some hardener.


Bob Dunahugh78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org




Cary, NC 1978 Center Kitchen Royale.
Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293546 is a reply to message #293527] Fri, 08 January 2016 13:18 Go to previous messageGo to next message
BobDunahugh is currently offline  BobDunahugh   United States
Messages: 2465
Registered: October 2010
Location: Cedar Rapids, IA
Karma: 11
Senior Member
Pete. The paint brand that I used was Nason acrylic enamel. Formerly DuPont. The Royale color is from a 2011 Mercedes ( light ivory ) with a minor tint added. I'd have to look at the can for the tint code.Bob Dunahugh 319-521-4891 Iowa


I used non hardened acrylic. Since I didn't put any thinner in the paint. It got hard enough, that I could work it down with the paper towel with thinner on the towel in about 15 minutes. And get the surface flat, and smooth. As to durability. I was only doing chips, and small scratches. It'll look great for along time. If you want. Put in some hardener.


Bob Dunahugh78 Royale
_______________________________________________
GMCnet mailing list
Unsubscribe or Change List Options:
http://list.gmcnet.org/mailman/listinfo/gmclist_list.gmcnet.org

Re: [GMCnet] Restoration. Fixing those little paint chips. And not have it show. [message #293555 is a reply to message #293524] Fri, 08 January 2016 15:33 Go to previous message
KB is currently offline  KB   United States
Messages: 1262
Registered: September 2009
Karma: 0
Senior Member
kerry pinkerton wrote on Thu, 07 January 2016 18:09

I'm not sure you can even get hardened paint products on the left coast any more. I have no idea how to use waterborne products.


Summit Racing sells all kinds of paints, and some of it can even be shipped here to California.
Just have to stick with the "low VOC" versions. I painted our coach with their Single Stage Acrylic Urethane.
Looked pretty decent (at least at 20' or so) but then we had a huge windstorm that caused part of
the cheesy shelter it's under to act like a battering ram on the right quarter of the nose.
Now I have a bunch of ugly dings to fix...

thanks,
Karen
1975 26'



Previous Topic: [GMCnet] Cherie Klakoski - long-time GMC member
Next Topic: [GMCnet] Total Solar Eclipse August 21st 2017
Goto Forum:
  


Current Time: Mon Sep 30 04:40:18 CDT 2024

Total time taken to generate the page: 0.01261 seconds