GMCforum
For enthusiast of the Classic GMC Motorhome built from 1973 to 1978. A web-based mirror of the GMCnet mailing list.

Home » Public Forums » GMCnet » Setting the front ride height procedure
Re: Setting the front ride height procedure [message #292825 is a reply to message #292808] Wed, 23 December 2015 17:38 Go to previous messageGo to previous message
Scott Nutter is currently offline  Scott Nutter   United States
Messages: 782
Registered: January 2015
Location: Houston/San Diego
Karma:
Senior Member
As far as lifting up the front end........and once again, I haven't done this before...........
If the wheels are on the ground, not jacked up, with the unloader tool in place and the bolt tightened up to take the tension off the adjustment bolt. Shouldn't the adjustment bolt be able to be unscrewed with a socket? I don't see where any thing would be blocking it from being loosened....


Scott Nutter 1978 Royale Center Kitchen, Patterson 455, switch pitch tranny, 3.21 final drive, Quad bags, Dave Lenzi super duty mid axle disc brakes, tankless water heater, everything Lenzi. Alex Ferrera installed MSD Atomic EFI Houston, Texas
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Off Topic: Owner's Manual for 2003-2009 GMC Topkick / Chevy Kodiak
Next Topic: [GMCnet] Restoration, Pictures of burned GMC good b
Goto Forum:
  


Current Time: Mon Jun 17 14:25:01 CDT 2024

Total time taken to generate the page: 0.01420 seconds