Home » Public Forums » GMCnet » Carb / Vacuum issue
Re: Carb / Vacuum issue [message #288598 is a reply to message #288585] |
Mon, 12 October 2015 17:45 |
bpimm
Messages: 211 Registered: June 2013 Location: Washougal Washington
Karma:
|
Senior Member |
|
|
JohnL455 wrote on Mon, 12 October 2015 14:24I'm betting a float/needle seat issue. 1) how do you know the spec height number you are using is correct for this application? 2) even if set correctly the needle seat can be slightly bad and cause flooding over. The primary rods properly in or stuck out in enrichment mode should not matter at base idle. Are you sure your float is not gas logged?
Early on the float stuck down and flooded over big time, gas flowing out the vent tube and puddling on top of the engine, I rebuilt the carb put in new needle and seat and float and it seemed to be better no more flooding over, I think it was drawing fuel from the primaries at idle after the rebuild, I hadn't even looked at it before the great flood. After the rebuild is when I found the water in the gas tanks so I drained and flushed them, added a 12 micron water separator/fuel filter and used it for the summer last year, a few short trips. This last winter I pulled the tanks and rebuilt the whole fuel system.
I'm going to order another kit for it and see if the needle and seat may have been the culprit, I disassembled it today and they look new, nothing looks out of place or bad so far.
Brian & RaeDean
1973 26' #383
Washougal WA
|
|
|
|
|
Carb / Vacuum issue
By: bpimm on Mon, 12 October 2015 10:33
|
|
|
Re: Carb / Vacuum issue
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Mon, 12 October 2015 11:23
|
|
|
Re: Carb / Vacuum issue
|
|
|
Re: Carb / Vacuum issue
|
|
|
Re: Carb / Vacuum issue
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Mon, 12 October 2015 12:05
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: USAussie on Mon, 12 October 2015 15:36
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: bpimm on Mon, 12 October 2015 17:31
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: bpimm on Tue, 13 October 2015 10:01
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: Loffen on Tue, 13 October 2015 11:32
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: USAussie on Tue, 13 October 2015 17:19
|
|
|
Re: Carb / Vacuum issue
By: JohnL455 on Mon, 12 October 2015 16:24
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Mon, 12 October 2015 17:45
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: k2gkk on Mon, 12 October 2015 18:00
|
|
|
Re: Carb / Vacuum issue
By: JohnL455 on Mon, 12 October 2015 19:09
|
|
|
Re: Carb / Vacuum issue
By: mercdave on Mon, 12 October 2015 19:44
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Mon, 12 October 2015 20:09
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Tue, 13 October 2015 14:07
|
|
|
Re: Carb / Vacuum issue
By: roy1 on Tue, 13 October 2015 14:28
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Tue, 13 October 2015 14:59
|
|
|
Re: [GMCnet] Carb / Vacuum issue
By: Kosier on Tue, 13 October 2015 21:07
|
|
|
Re: Carb / Vacuum issue
By: mercdave on Tue, 13 October 2015 14:45
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Tue, 13 October 2015 15:17
|
|
|
Re: Carb / Vacuum issue
By: Loffen on Tue, 13 October 2015 16:15
|
|
|
Re: Carb / Vacuum issue
By: bpimm on Tue, 13 October 2015 17:38
|
Goto Forum:
Current Time: Fri Sep 27 17:11:22 CDT 2024
Total time taken to generate the page: 0.00651 seconds
|