| Onan [message #288111] |
Thu, 01 October 2015 18:53  |
Bill Shourt
Messages: 33
Registered: January 2005
Location: Sherman Oaks ,Ca
Karma:
|
Member |
|
|
A couple of months ago I replaced my circuit board with a dino board from Jim K but my starter would stay engaged about one time in ten that I tried it. If I pulled the lead to the starter solenoid it would disengage. I checked that wire after I pulled it off and there was no voltage. I next replaced the K1 starting relay with a new one. same thing happens. I have been using the coach quite a bit this summer so I ran a line inside the coach with a switch between K1 and the starter solenoid so I can disengage the starter if it stays going (about 10,000 rpm ?). Not the solution I want.
It will happen from inside switch as well as Onan start switch. I am baffled . Thanks for any thoughts form the group.
Bill and Michele Shourt
78 Kingsley, origional
|
|
|
|
GMCforum
Search
Help
Register
Login
Home
